Super Systems 20PQ User Manual

Page 39

CnF. 2

- Filter on auxiliary input - [C.d13]

This parameter is available only when auxiliary input is
configured
Ranges: from 0 (no filter) to 8 seconds.
NOTE: this is a first order digital filter applied to the measured
value made by the auxiliary input.

General note about configuration group 1
Exiting from the configuration group 1 the instrument automati-
cally verifies the programmed span for the linear input.
If it is wrong, the device will show:

Push the FUNC pushbutton more times until the "ñ.In.L" [C.d05]
or "ñ.In.H" [C.d06] are displayed and modify their value in order
to respect the minimum read-out span (see NOTE 2 of the
"ñ.In.H" [C.d06] parameter).

CONFIGURATION GROUP 2 [C.Exx]
OUTPUTS CONFIGURATION

- OUT 1 function - [C.E01]

Range: nonE = Output not used

ñAin

= Time proportional main control output

SECn = Time proportional secondary control output
ALr.1 = Alarm 1 output
Eun.1 = Event 1 output

NOTE: for Event description see "Event 1

function" [C.H.09] parameter.

XKP-1-C2.p65

10/30/01, 9:37 AM