Super Systems 20PQ - Manual (Page 155)

A. 1
DEFAULT PARAMETERS
General notes:
A complete and consistent set of run time and configuration
parameters is memorized in the instrument. These data are the
typical values loaded in the instrument prior to shipment from
factory.
With these instruments it is also possible to save the user run
time and configuration parameters setting and load them again
when necessary (for more details see "Default configuration and
user parameters" at pag. A.6).
DEFAULT RUN TIME PARAMETERS
This instrument allows to load the default value of a single run
time parameter group or to load all the run time parameters
(exception made for "Run time group 8" [r.Hxx] and "Run time
group P").
A) When it is desired to load the default parameter of a single
group, proceed as follows:
A.1) By MENU pushbutton, select the desired run time
parameter group.
A.2) By FUNC pushbutton, select the last parameter of the
selected group.
The middle and lower display will show:
A.3) By s or t pushbuttons, select the "On" indication on
the central display.
A.4) Push the FUNC pushbutton.
The central display will show:
The default parameter loading procedure for the selected
group is ended.
B) When it is desired to load the default value of all the run time
parameters (exception made for "Run rime group 8"[r.Hxx]
and "Run time group P"), proceed as follows:
B.1) By MENU pushbutton, select the "Run time group dF"
[r.Lxx].
B.2) Push the FUNC pushbutton.
The middle and lower display will show:
B.3) By s or t pushbuttons, select the "On" indication on
the central display.
XkP-A-C2.P65 10/30/01, 9:44 AM 1