Smithco Envizio Pro Installation & Operation Manual - Manual (Page 59)

5
Manual No. 016-0171-148 49
Startup, Initial Setup and Setup Wizards
Product Control Setup Wizard
The product control setup wizard will require the following information for each product connected to the
Envizio Pro or Envizio Pro II CANbus control system:
• Speed cal and sensor type
• Application type
• Valve cal and valve type
• Meter cal
• Rate cal
• Section assignments
Note:
By default, the product controller node is set to provide two control channels for the field computer.
The initial configuration wizard will need to be completed before the number of control channels
may be modified.
Using the Product Control Setup Wizard
1. Touch the product control setup wizard icon. The Speed Cal screen will display.
2. Select the type of speed sensor which will be used with the control system.
3. Touch the button labeled Speed Cal and use the on-screen keypad to enter the calibration value for the
speed sensor installed on the vehicle.
Raven Industries recommends the following speed calibration values for initial system setup.
These values are good starting points and generally yield adequate results, however, the speed cal should
Sensor Type
Setting
Used with English Metric
Radar/GPS
External Raven GPS
Receiver
785 199
Internal DGPS Receiver 812 206
GPS Speed over CANbus 1000 254
Raven Radar 598 152
Wheel
Wheel Magnets 1000 254
Speedometer Drive Speed
Sensor
612 155