Additional calibration data, Entering tank volume, Reset volume/area display information – Smithco Envizio Pro Installation & Operation Manual User Manual
Page 196: Reset display distance
Appendix A
186
Envizio Pro and Envizio Pro II Installation and Operation Manual
Additional Calibration Data
Although not required operation, the following values may be programmed to enhance feedback for the
operator during field application.
Entering Tank Volume
Press VOLUME/TANK and use the Edit mode to enter an estimated volume of product in the tank or bin. This
setting must be reset each time the tank or bin is refilled.
Low Tank Alarm
The field computer may be set to display or sound or an alarm when the calculated volume of product
remaining in the in the tank falls to a user defined level. To setup the Low Tank Alarm, refer to the Alarm
Settings section on page 112.
Reset Volume/Area Display Information
The current total area, total volume, field area and field volume information is displayed as applied information
that can be reset at any time. Refer to the Volume and Area Settings section on page 109 to reset these
display values.
Reset Display Distance
The current display distance, or odometer, registered by the field computer may be reset at any time. Refer to
the Speed section on page 99 for more information.