Section assignments, Accuboom, Autoboom – Smithco Envizio Pro Installation & Operation Manual User Manual
Page 124
Chapter 7
114
Envizio Pro and Envizio Pro II Installation and Operation Manual
Section Assignments
The Section Assignment screen allows the operator to assign products to a section. Place a green check mark
below a section to assign the selected product to that section.
Note:
The vehicle or implement’s plumbing must accommodate the selected section assignments.
AccuBoom™
Touch this icon to display the AccuBoom Setup screen. See Chapter 9, Using AccuBoom™, for more
information on setting up and using AccuBoom with the Envizio Pro or Envizio Pro II.
Note:
If no AccuBoom node is detected by the CANbus, a Function Disabled screen will appear. If an
AccuBoom node has been installed, troubleshoot the node and readdress the CANbus. See
Chapter 4, CAN Networking and Diagnostics, for CAN installation and troubleshooting information.
AutoBoom™
Touch this icon to display the AutoBoom Setup screen. See Chapter 10, Using AutoBoom™, for a brief
overview of this feature on the Envizio Pro and Envizio Pro II. Refer to the AutoBoom Calibration & Operation
Manual for calibration and detailed operation instructions.
Note:
If no AutoBoom node is detected by the CANbus, a Function Disabled screen will appear.
Troubleshoot the node and readdress the CANbus. See Chapter 4, CAN Networking and
Diagnostics, for CAN installation and troubleshooting information.