Smithco Envizio Pro Installation & Operation Manual - Manual (Page 176)

Chapter 10
166 Envizio Pro and Envizio Pro II Installation and Operation Manual
UltraGlide
UltraGlide AutoBoom replaces the gauge wheels with state-of-the-art ultrasonic sensors to measure the
boom’s height above the ground. Since no part of the machine must come into contact with the ground or crop,
UltraGlide systems are ideal for use in post-emergent as well as pre-emergent applications.
Note:
Terrain conditions as well as the machine’s hydraulic system will dictate the actual speeds which
may be achieved while applying with an Engaged AutoBoom system. Typically, rougher and more
varied field terrain will require slower AutoBoom application speeds.
AutoBoom™ Operation
Once properly calibrated, operation of the AutoBoom feature with the Envizio Pro or Envizio Pro II is as easy
as toggling the feature on and enabling height control for each boom. AutoBoom must be both On and Enabled
for each boom before the system will manage boom height. The field computer does not require an active job
to enable the AutoBoom feature.
Status Display
During a job, the status of the AutoBoom system is displayed on the Guidance screen.
Touch the AutoBoom Status Display to view the main AutoBoom Settings screen.
Note:
If operating with an UltraGlide AutoBoom system, the set Sensor Height is displayed in the Status
Display. If an optional center rack sensor is installed, the actual height of the center rack will be
displayed in this area.