Smithco Envizio Pro Installation & Operation Manual - Manual (Page 35)

Manual No. 016-0171-148 25
Installation
The Envizio Pro or Envizio Pro II may be connected to a Raven serial control console via a serial port
connection. In this configuration, the field computer is primarily used for the datalogging, mapping and
guidance capabilities.
Note:
If connected to a serial control console, the field computer does not require a separate boom/
speed or product control node. An AccuBoom, AutoBoom or SmarTrax node still may be
connected to the field computer.
Use one of the following Raven RS-232 cables to connect the serial port on the back of the serial control
console to the connector labeled ‘Console’ on the Envizio Pro main interface cable (P/N 115-0171-746).
Note:
Use only a Raven RS-232 communication cable between the field computer and the serial control
console. Contact a local Raven dealer for purchasing and more information.
See Chapter 7, Tools Menu, to setup the field computer for the serial console connection.
AutoBoom™
Follow the machine or implement specific installation manual to install the AutoBoom hydraulic valve and
hoses.
CANbus Network Connection
Envizio Pro and Envizio Pro II field computers are capable of controlling up to four product nodes or control
channels (with required activation keys) on a CANbus system. The field computer will automatically scan for
CAN product control, planter control, AccuBoom, AutoBoom, SmarTrax, boom sense and speed nodes
connected through the CAN connection.
See Chapter 4, CAN Networking and Diagnostics, for additional information.
Description Part Number
RS-232 cable - 3 ft. 115-0171-040
RS-232 cable - 10 ft. 115-0159-822
NOTICE
Read all safety requirements and precautions in
the machine specific installation manual prior to
operating a machine equipped with the
AutoBoom feature. Failure to follow safety
precautions may lead to damage to equipment,
injury or death.