Offsets – Smithco Envizio Pro Installation & Operation Manual User Manual
Page 140
Chapter 7
130
Envizio Pro and Envizio Pro II Installation and Operation Manual
Offsets
To properly display the vehicle location within a field and create accurate coverage information, the field
computer must be calibrated for the location of the center of the boom or implement relative to the GPS
antenna. This allows the field computer to provide accurate field guidance and create coverage maps based on
the location of the boom or implement.
Touch the Offsets icon to display the Raven Offsets Setup screen.
The Offsets Setup screen displays the following:
•
Antenna Position Display - Displays a visual reference of the location of the boom or implement and DGPS
antenna. After the antenna offsets are programmed, the antenna position display should show a general
representation of the machine configuration.
Note:
The direction of forward travel shown on the antenna position display is toward the top of the
screen.
•
List of offsets and currently set values for each setting. To enter or change an value, touch the desired offset
and use the on-screen keypad to enter the new value.
•
Current boom or implement location selection.
Current Offset
Values
Live Antenna
Position Display
Boom/Implement
Location Selection
DGPS Antenna
Center of Boom/
Implement
Current Offset Units