Smithco Envizio Pro Installation & Operation Manual - Manual (Page 50)

Chapter 5
40 Envizio Pro and Envizio Pro II Installation and Operation Manual
Left or Right Offset
The left/right offset is the distance from the GPS antenna to the center line of the boom or implement.
Note:
The left/right offset must be measured parallel to the boom or implement width. See Figure 2
below.
To set the left/right value:
1. Touch the current left/right value displayed on the Raven Offsets Setup screen.
2. Use the keypad to enter the measured left/right value in inches (U.S.) or centimeters (Metric).
3. If the center line of the boom or implement is to the left of the GPS antenna, select the ‘Left of Center’
option.
FIGURE 2. Example of Left/Right Measurement
Height
The height value is the measurement from the ground to the bottom of the GPS antenna.
To set the Height value:
1. Touch the current height value displayed on the Raven Offsets Setup screen.
2. Use the keypad to enter the measured height of the antenna in inches (U.S.) or centimeters (Metric).
DGPS Antenna
Center of Boom/
Implement
Left/Right
Measurement