Measurement Computing eZ-PostView rev.2.0 - Manual (Page 97)

eZ-Analyst 969795 Edit Menu 4-19
Understanding Total Measured Data
In this figure, the Start Recording panel’s PreAcq-Trigger data and the Stop Recording Panel’s
Trigger Delay data are both saved as part of the total measured data.
Edit Menu > Configuration > Recording Setup Tab: Stop Recording Panel
Provide a means of setting the following parameters that pertain directly to stop recording:
Recording Duration sets a “time-out” which the recording event is not to exceed. If an
acquisition has been triggered, the measurement will run until either (a) the amplitude-based
Enable Stop Trigger Condition is met, or (b) the Recording Duration is met, whichever occurs
first. When the Recording Duration value is met, the recording event is aborted.
Note: Entering a value of “0” in the Recording Duration block sets the duration to infinity.
Enable Stop Trigger – if the checkbox is checked, amplitude-based data can be set as a
stop condition for the recording. The following options are provided.
Amplitude-Based
Data Types
Peak Time >=
Peak Time < Spectrum >=
Spectrum <
at specified frequency
Delay (sec) – this function is used to include [with the recording] data that follows the stop
trigger event by the set number of seconds, as specified by the delay.
Maximum Duration Limit Terminating a Measurement