Measurement Computing eZ-PostView rev.2.0 - Manual (Page 73)

eZ-Analyst 979595 Menus 3-15
Locations
This window displays the current modal locations. The window only applies to eZ-Analyst and
to eZ-FrequencyView.
Modal Locations Window
As it appears in eZ-Analyst
Modal Locations Window
As it appears in eZ-FrequencyView
Clicking on the left or right arrow keys [ or buttons in eZ-FrequencyView]
increments or decrements the modal locations based on the bank setup criteria set in the
Configuration - FFT Setup Tab. The change in locations is dependent upon the active reference
and response channels, and whether Response Increase or Reference Increase is selected.
Tachometer
Tachometer
as seen in eZ-Analyst
Tachometer
as seen in eZ-TimeView
and in eZ-FrequencyView
This window displays three fields: tachometer channel number, measurement, and units.
Tachometer channels are set up in the Input Channels Window. See the Tach Channels
section of chapter 4 for additional information. Tachometer does not apply to eZ-PostView .