Measurement Computing eZ-PostView rev.2.0 - Manual (Page 62)

3-4 Menus 979595 eZ-Analyst
ZonicBook Medallion Applications
Auto-ranging works best if you supply the maximum expected voltage range for the data that will be
captured during the acquisition.
For ZonicBook Medallion the AutoRange window can be accessed from the Task pull-down menu when in
Measurement Mode. The window has four basic sections: Mode panel, Starting FSV panel, Channel Gauges,
and a %, FSV, Factors Display d
isplay.
AutoRange Display, from a ZonicBook Medallion
Mode
The Mode panel consists of three radio buttons, which are used to select one of the following
range modes: AutoRange(%), AutoRange(V), or ManualRange(V).
Starting FSV
The Starting FSV (Full Scale Voltage) panel consists of three radio buttons, which are used to
set the starting FSV to Maximum, Minimum, or Current.
Channel Gauges
The channel gauges, one per channel, display the instantaneous peak value as percentage or
voltage, depending on the mode that was selected. The color of the vertical bar has the
following significance:
Yellow The signal range is from 0 to the minimum Full-Scale Voltage set in the Auto-range Setup
window.
Green The signal range is from the minimum to the maximum of the Full-Scale Voltage set in the
Auto-range Setup window.
Red The signal range is over the maximum of the Full-Scale Voltage set in the Auto-range Setup
window.
Channel Active, if checked
Current Full Scale Voltage (FSV)
% of Full Scale