Measurement Computing eZ-PostView rev.2.0 - Manual (Page 50)

1-8 Software Installation, ZonicBook Medallion 979595 eZ-Analyst
ZonicBook Medallion, Hardware Setup and DSP-Card Installation (All Windows Systems)
Reference Note:
If you have not already set up your hardware and installed your DSP-
card, refer to your ZonicBook User’s Manual (p/n 1086-0901), and do so
at this time.
ZonicBook Medallion, Verifying DSP-Card Installation
You can use the Window’s Device Manager to verify that the DSP-card has been properly
installed.
The steps for this method are as follows.
1. From the Windows Desktop, click .
2. Click Settings.
3. Click Control Panel.
4. Click the System icon.
5. Click the “Device Manager” tab.
6. Locate one of the following nodes, as applicable to you Window’s operating
system.
• Windows 98 and Windows Me users should locate a node called D32DSP.
• Windows 2000, Windows XP, Windows NT users should locate a node
called CACDSP.
7. Expand that node by clicking on the “+” symbol.
At this point you should see a screen similar to one of the following, depending on
which operating system your PC is using.
DSP Verification, Windows 98 and Windows Me
DSP Verification, Windows 2000
DSP Verification, Windows XP
Note: A screen image is not shown for Windows NT. However, Windows NT makes
use of a CACDSP node, as do Windows 2000 and Windows NT.