Measurement Computing eZ-PostView rev.2.0 - Manual (Page 72)

3-14 Menus 979595 eZ-Analyst
Window Menu
> Delete Window
Deletes the window that is currently in focus. When multiple plot windows are open, one is
always the “focus window. When a window does not have focus, its title bar is dimmed. To
change the “focus window,” simply click on top or side border of the window of interest.
Window Menu > Input Channels
The Input Channels window is selected from the eZ-Analyst Windows pull-down menu. This
Window only applies to eZ-Analyst.
Buttons
When selected, “Buttons” removes the channel button boxes from the toolbar and displays
them in a floating window. The buttons are used in the exact same manner as when they were
located on eZ-Analyst’s main window. Removing the checkmark from “Buttons” places the
channel buttons back onto the toolbar. Note that the button [located
on the toolbar, just to the left of where the channel buttons reside] provides the same
functionality. See chapter 5 for location.
• To add a channel: use the mouse to click and drag a channel box from the
complete channel button display into the plot area.
• To remove a channel: use the mouse to click and drag a channel box (from the
right-side of the plot) into the plot area.
Status
The Status dialog box (following figure) uses a chart to indicate the followings:
• Volts linear
• percent of the Full-Scale Voltage (FSV)
The status box includes “maximum” bars to show the highest level of signal value reached by
each channel during the measurement process.
Status
Meas V Measured Voltage
+/- FSV The Full-Scale Voltage
Delta % The percentage difference between the measured voltage
and the Full-Scale voltage, such that Meas V is n% of FSV;
with n being the value of Delta %.