Gasboy 1000 Series FMS Diagnostic Manual - Manual (Page 87)

GASBOY Series 1000
6-2 03/07/03
Problem Symptoms Page
Auxiliary port communication Unable to communicate to the tank monitor through
the Series 1000.
The Series 1000 communicates with its two main communication
ports and accepts card and keypad input for fueling. 6-25
Receipt printer Series 1000 does not print any receipts and may not prompt
for receipts.
Receipts are printed but cutter bar does not cut receipts.
Receipts are printed but don't cut completely across the paper.
Paper doesn't advance while printing receipts, printing in self-test
or when paper feed switch is pressed.
Printing appears light.
Portion of printed characters is missing.
Paper low lamp is lit.
Paper low lamp never lights.
Paper out lamp is lit.
Paper out lamp never lights.
Printer can't enter self-test; can't exit self-test. 6-27
SERVICE NOTES
Before beginning any troubleshooting session, it is wise to follow these steps:
● Perform a visual inspection of the system to ensure that it is installed according to the
Installation Manual.
● Ensure that all cables and switch settings are connected or set properly. See the Installation
Manual and the Start-Up Manual for further details.
● Measure the DC power supply output voltages to ensure they are within proper operating
tolerances. See Test Power Supply later in this section.
● Turn off system power before servicing.
The procedures in this section assume you have opened the rear door and removed the hood.