Gasboy 1000 Series FMS Diagnostic Manual - Manual (Page 69)

GASBOY Series 1000
4-10 03/07/03
RECEIPT PRINTER MAINTENANCE
Ordering New Paper or Ribbon
When replacing paper or ribbon, use only GASBOY-supplied parts. Failure to do so will void the
GASBOY warranty.
● C08946 Paper, #RF-4, 5-5, Low Bulk - Star
● C08941 Ribbon, #SF-01P, Purple - Star
It is recommended, in most cases, that the ribbon be replaced every 4000-5000 receipts or 2 to 3
rolls of paper to ensure acceptable print quality. Environmental conditions, such as temperature
and humidity, may affect the life of the ribbon.
Accessing the Printer
Before beginning any of the following maintenance procedures, you must pull the printer out to a
serviceable position. Follow these steps:
1. Open the printer access door and loosen the hex head screw.
2. Pivot the printer assembly to the right in order to clear the paper chute.
3. Pull the entire printer slide assembly toward you.
4. Perform any required maintenance or service. Reverse this procedure to return the printer to
normal operation.