Gasboy SCII POS - Manual (Page 32)

Point of Sale and Shift Change Files, menus, and reports 25
03/07/03 Gasboy CFN Series
RUNNING FILES ON A CHECK POINT
As indicated in the above charts on the clerk and manager menus, you can run certain files on the
Site Controller from the Check Point. These sixteen files are named CON01.CMD —
CON16.CMD. You can define the function of these files yourself-that is why they are called user-
defined command files—or you can use their default configurations, which execute specific
commands.
On the Check Point, each of these sixteen files is “attached” to one of the sixteen pump keys (the
keynames below have a P to indicate they are pump keys, though the P does not appear on the
actual key). Run a user-defined CON0?.CMD file by turning the Check Point’s keyswitch to
Manager and pressing the appropriate pump key:
Key User-defined file Command file Function
P1
CON01.CMD NEXTDAY.CMD end the day and print report
P2 CON02.CMD NEXTSHFT.CMD end the shift and print report
P3
CON03.CMD COUNT.CMD record cash in drawer and final safe drop
P4
CON04.CMD REPORT.CMD yday regenerate last end-of-day report
P5
CON05.CMD SHOWSTAT.CMD console status report
P6
CON06.CMD REPRINT.CMD last reprint last report
P7
CON07.CMD SAFEDROP.CMD record safe drop
P8
CON08.CMD ADDRAWER.CMD add change to drawer
P9
CON09.CMD LDDRAWER.CMD load starting drawer balance
P10 CON10.CMD REPRINT.CMD day reprint last end-of-day report
P11
CON11.CMD REPORT.CMD shft regenerate shift report for current day
P12
CON12.CMD REPORT.CMD pday regenerate a previous end-of-day report
P13
CON13.CMD REPORT.CMD pshft regenerate shift report for a previous day
P14
CON14.CMD REPRINT.CMD pday reprint any end-of-day report
P15
CON15.CMD REPRINT.CMD shft reprint shift report
P16
CON16.CMD no default function