Gasboy SCII POS - Manual (Page 25)

18 Command Syntax Point of Sale and Shift Change
Gasboy CFN Series 03/07/03
The syntax for the LISTDAY 0 command is:
LISTDAY 0 [POS#] [Shift POS #1] [Shift POS #2] [Shift POS #3][Shift POS #4]
[Drop][Initial drawer total][current drawer total]
When the day closes without being interrupted, the PREVIOUS.LOG file is not in the root
directory. So when you run the NEXTDAY command with a PREVIOUS.LOG file in the root
directory, the command assumes the day-closing has been interrupted and continues processing the
PREVIOUS.LOG file in the root directory without closing the current day. The NEXT DAY
command is not run and the LISTDAY 1 command is run in background to complete the
processing of the PREVIOUS.LOG file.
The syntax for the LISTDAY 1 command is:
LISTDAY 1 [POS#] [Shift POS #1] [Shift POS #2] [Shift POS #3] [Shift POS #4] [Drop]
[Initial drawer total][current drawer total]
When the clerk is not required to close the prior shift, the LISTDAY command runs the
LISTNEXT command in background to generate shift reports and the LISTONE command to
generate the end-of-day report. When the clerk is required to close the prior shift, the data needed
to generate the shift report is stored in a file, and the shift report is generated after the final safe
drop has been made using the COUNT command.
After all shift reports have been processed, the LISTONE command is used to generate the end-of-
day report. The end-of-day report is printed on the printer(s) it is configured to print on. When the
end-of-day report is configured to print on the receipt printer, the LISTONE command uses the
POS number associated with the receipt printer to determine which receipt printer will print the
report.
The syntax for the LISTNEXT command is the same as shown above for the NEXTSHFT
command. The syntax for the LISTONE command is:
LISTONE [Extension] [POS#] [Trans]
Trans is the transaction number of the last transaction of the previous day.
The LISTONE command runs CASHIER and PRBOTH to generate the end-of-day reports. The
arguments specified by the standard end-of-day format file are the day of the week, date, site ID,
system shift reference number and datetime. The arguments for PRBOTH are the journal log file
and the flat file.
The syntax for the CASHIER and PRBOTH commands is shown below:
CASHIER [Journal] [Format] [Flat] [Day] [Date] [SiteID] [Serial] [Datetime]
PRBOTH [-i|u] [-h] [Journal] -f [Flat]
PRBOTH is not supported in software versions below V3.4.
PRITEM.BIN and PRHOUR.BIN have been replaced by command files PRITEM.CMD and
PRHOUR.CMD, with the same syntax.
PRITEM [Journal] -f [Flat]
PRHOUR [Journal] -f [Flat]
PRNTRPT [Report type] [Report number] [Day of week extension] [Date and time][Printer
POS] [Report flag]
REPRINT A REPORT
The REPRINT command is used to reprint an existing shift or end-of-day report.
The first argument is always the POS number of the receipt printer used to reprint the report,
followed by the type of report to be reprinted.