Gasboy SCII POS - Manual (Page 22)

Point of Sale and Shift Change Command Syntax 15
03/07/03 Gasboy CFN Series
REPORT CONFIGURATION
The SETUP SHIFT, SETUP DAY, and SETUP CLERK commands are used to customize the shift
and end-of-day reports on the site.
The SETUP commands make a copy of the existing format file that can be used to undo the
changes. After making a copy of the existing format file, SETUP runs the ALTER command to
create a new format file for either the shift or end-of-day reports. After the ALTER command
finishes, the FMTLINT command is run to output the memory utilization to the screen.
The syntax for using SETUP, ALTER, and FMTLINT are shown below:
SETUP SHIFT
SETUP DAY
SETUP CLERK
ALTER CLERK
ALTER SHIFT
ALTER DAY
FMTLINT [filename]
NOTE: SETUP SHIFT -D, SETUP DAY -D, and SETUP CLERK -D are used to generate the
default report configuration for demo purposes. Running these command wipes out the existing
report configuration, so do not run them on a working site!
The syntax for using UNINSTAL to recover the report configuration and ALTER for demo
purposes is:
SETUP SHIFT -D
SETUP DAY -D
SETUP CLERK -D
END THE SHIFT
The NEXTSHFT command is used to change shift on a particular POS, each POS, create a clerk
report, or change shift for an attendant.
The syntax for using the NEXTSHFT command is:
NEXTSHFT [n] [-?] [-s] [-c[n]] [-a[n]] [-pn] [-dn] [-on]
Loads next shift and prints report for console or clerk/fueler id number
n Changes shift for console n and prints shift report
-? Displays this message
-s Changes shift for all console at Site and prints unique shift reports
-c[n] Changes shift and prints report for Clerk id number n
-a[n] Changes shift and prints report for Attendant number n
-pn Prints report to console n.
-dn specifies n number of digits in attendant number.
-on specifies n number of offset digits into card data for attendant number.
The Unique shift #’s for every console parameter must be set to Yes, because the standard shift
format files do not support doing a shift change on the whole system. They support only shift
changes on a POS-by-POS basis.