Fluke Biomedical medSim 300B - Manual (Page 36)

medSim 300B
Operators Manual
3-8
In the step menu, the top display line indicates the name of the parameter being
modified and a value for it. If the value shown (illustrated above as "#.##") is
active, it flashes.
2. Press -DOWN or -UP to decrement or increment the displayed value.
3. Press -EXC to execute the displayed value.
4. Press -AUTO and the bottom display line changes as follows:
ecg amp, lead II: #.## mv
down up strt man
eic005.eps
In this mode, use of the -DOWN key and the -UP key decrements and
increments the displayed value, and immediately executes the selected value
without requiring a separate "execute" key.
Note
Use of the -MAN key returns to the previous mode.
5. To activate the automatic stepping mode, press the -STRT key and the
display changes to:
ecg amp, lead II: #.## mv
down up stop
eic006.eps
At this point, the parameter is automatically stepping at a predetermined rate
(refer to the "Specifications" chapter). Upon reaching either limit, the stepping
switches directions and continues.
6. Choose -DOWN or -UP to reverse the incrementing and decrementing
of the values.
7. Press -STOP to stop the stepping and return to the manual mode.
8. Pressing the also stops automatic stepping and moves you back up
through the menu.
Only one automatic stepping mode can be active at a time.