Baby Lock ProStitcher Version 14.04.0051 (BLPS3) Instruction and Reference Guide User Manual
Page 88

8.4 | Settings Menu
Pro-Stitcher User Manual
To select the method of tie-off stitch: Micro or Tack
• Press Tack to select the Tack method of
tie-off. The Tack method forms the selected
number of stitches forward into the design
and then back to the start point before
beginning to stitch the design, thus doubling
the number of stitches selected.
• Press Micro to select the Micro method
of tie-off. The Micro method forms the set
number of tie-off stitches forward into the
design and then begins stitching from there.
When stitching the design is coming to an
end, Pro-Stitcher stops stitching just before
the end point and performs the selected
number of tie-off stitches to the end of the
design. This method does not back over
itself and is more likely to be pulled loose
than the Tack method. However, it is much
less noticeable than the Tack method be-
cause there is no build-up of thread.
Control how Pro-Stitcher handles bobbin-thread pullups
Pro-Stitcher can be set to automatically pull up the bobbin thread at the start of stitching a design. It can
pull up the thread and automatically shift aside for you to grab the threads or it can pull up the thread and
enable you to manually move the machine aside to pull up the thread.
• Select Settings, Pullup.
To turn on bobbin-thread pullups
• Press Pull-Up On for Pro-Stitcher to perform a pull up at the beginning of the design and at the be-
ginning of each segment following a jump that exceeds the Auto Jump threshold.