beautypg.com

Baby Lock ProStitcher Version 14.04.0051 (BLPS3) Instruction and Reference Guide User Manual

Page 15

background image

Pro-Stitcher User Manual

Installation | 3.7

CAUTION: Do not use the larger drill bit included in the emergency repair kit, as this is the wrong

size for the Flexirack clamps.

NOTE: As an alternative, use one clamp at each end. Slide the lip of the clamp over the last gear

of the blue Flexirack, drill a pilot hole, and screw in place.

To install the Y-Rack

1. Carefully lay the quilting machine on its power pod

side (the left side, looking from the front).

Underneath the base plates, near the wheels on the

C-pod side of the machine (the side with the thread

tensioner and guides) there will be either two screws

or two holes. If the screws are there, use a large flat

screwdriver to remove the screws.

2. Attach the Y-Rack to the bottom of the front and rear

base plates. The blue Flexirack should be toward the

middle of the machine while the bolt holes should

be toward the outside. Use the screws that were

removed from the front and rear base plates (or use

the two smallest screws in the Base Plate Repair Kit

[see Parts List, item D] if your machine had no screws

here).

CAUTION: Be careful not to over-tighten the screws as the base plate holes will strip easily. In case

of accidentally cross-threading or stripping one of the base plate holes, an emergency repair kit

(see Parts List, item D) has been provided.

3. If the screws in the base plates do not have slotted heads and a nut driver cannot be fitted over the

screw head, use one of the provided slotted screws as a replacement (see Parts List, item D) and use a

slotted screwdriver to tighten the screws in place.

!

!

!