Baby Lock ProStitcher Version 14.04.0051 (BLPS3) Instruction and Reference Guide - Manual (Page 84)

Pro-Stitcher User Manual Quilt Menu | 7.11
Machine Quilting Tip: Recovering from a thread break or bobbin change
If the thread breaks while stitching, press Pause. Fix the problem by rethreading the
machine or changing the bobbin. Select the Quilt menu and then select the New Start/
End function. Then press the Start Auto button. Press Disable Motors. Move the machine’s
needle to the place on the quilt where you want to begin stitching again. The crosshairs
on the screen will move to the corresponding position on the design. If some fine tuning is
needed to move the new starting point forward or back in the design, use the left or right
arrows on the scroll bar until the new start point is exactly where desired. Press Start Auto
again. Use the Half Stitch button to pull up the bobbin thread. Press the Tie off on Resume
and Pullup on Resume buttons to disable. Press Resume to continue quilting.
If the quilt has shifted slightly and the point on the design does not match up exactly with
the point on the quilt, move the needle to the exact location on the quilt that matches the
new starting point that was just set. Then select Reposition on the Quilt menu and press
Start Point. The design shifts to align the new start point with the current needle position.
Double check the Tie Off and Pullup settings and press Resume to continue stitching the
design.