Baby Lock ProStitcher Version 14.04.0051 (BLPS3) Instruction and Reference Guide User Manual
Page 21

Pro-Stitcher User Manual
Installation | 3.13
To attach the tablet computer
1. Disconnect the front handlebar cable from the side of the machine’s head. Then remove the
handlebars from the front of the quilting machine by removing the three hex-head bolts with a 5mm
Allen wrench.
If you’re having difficulty reaching the front handlebar cable, first remove two of the hex-head
bolts and loosen the third bolt. Then, rotate the handlebar slightly to provide easier access to the
handlebar cable.
2. Make sure the three handlebar bolts are in the front
handlebar and protruding out the bottom of the
handlebar.
3. Position the handlebar over the computer bracket
such that the screws go through the three holes in
the bracket.
4. Secure the handlebar and bracket in place on the machine head using the three handlebar bolts.