Baby Lock ProStitcher Version 14.04.0051 (BLPS3) Instruction and Reference Guide - Manual (Page 82)

Pro-Stitcher User Manual Quilt Menu | 7.9
• Move the machine and crosshairs to the desired location and press the Current Point button under
Reposition. If the Start Point has been altered during a Pause, pressing Resume will cause the Pro-
Stitcher to resume from the adjusted Start Point rather than the Current Point.
To see how far into a design the machine has stitched
• After pausing the quilting, select Quilt and then select Status. Pro-Stitcher displays the line segment
being stitched and the distance traveled (in inches).
Machine Quilting Tip: Using the line segment and distance information
The line segment information is useful if you want to resume quilting from that exact point,
such as when you are quilting over-sized blocks and need to roll the quilt after quilting part
of the block. Make a note of the line segment and distance values so that you can begin
quilting again at that precise location.
The distance information may be useful in determining how much thread has been used.
Change the start or end point of a design
After the thread breaks or the bobbin runs out of thread, you may need to start quilting from a point other
than the design’s start point. Similarly, you may want to change the end point to a point other than the
design’s original end point and quilt only a part of the design.
Select Status to display
the line segment being
stitched and the
distance traveled
(in inches).