Baby Lock ProStitcher Version 14.04.0051 (BLPS3) Instruction and Reference Guide User Manual
Page 75

7.2 | Quilt Menu
Pro-Stitcher User Manual
In addition to doing a manual check, use the two Trace options to verify the position of the design’s
bounding box or the defined area relative to the quilt.
To verify the position of the design’s bounding box on the quilt
• Select Trace Box and then Run. Pro-Stitcher moves the machine around the perimeter of the
design, following the blue bounding box. Watch the needle position as the machine traces the
design’s bounding box to ensure the design will quilt where expected. If the Stitch button is enabled
(appears darker), Pro-Stitcher stitches, rather than traces, the bounding box.
To verify the position of the defined area on the quilt
• Select Trace Area and then Run. Pro-Stitcher moves the machine around the perimeter of the
defined area, shown as purple lines on the screen. Watch the needle position as the machine traces
the area’s perimeter to ensure the design will quilt where expected. If the Stitch button is enabled
(appears darker), Pro-Stitcher stitches, rather than traces, the perimeter of the area.
NOTE: If you’ve enabled the Stitch button to stitch rather than trace the bounding box or the
perimeter of the area, you must manually do tieoffs at the beginning and end of stitching.
!
A dot indicates
the start point for
the area.
The design’s bounding
box