Baby Lock ProStitcher Version 14.04.0051 (BLPS3) Instruction and Reference Guide User Manual
Page 83

7.10 | Quilt Menu
Pro-Stitcher User Manual
To begin quilting from a point other than the design’s start point
• Position the needle where you want to begin stitching and select Start Auto. The point in the design
that is closest to the crosshairs will be the new start point. Alternately, drag the top scroll bar to
move the start point to a new position in the design.
To end quilting at a point other than the design’s end point
• Position the needle where you want to end stitching and select Stop Auto. The point in the design
that is closest to the crosshairs will be the new end point. Alternately, drag the bottom scroll bar to
move the end point to a new position in the design.
NOTE: If you select a start point that is beyond the current end point in the design, the end point is
adjusted to follow the start point. Similarly, if you select a end point that is before the current start
point in the design, the start point is adjusted to come before the end point.
NOTE: If the Start Auto or Stop Auto buttons are selected, the start or end points continue to move
as you move the machine and crosshairs.
To adjust start and end points with the scroll bars
The upper scroll bar controls the start point and the lower scroll bar controls the end point.
• Use the left and right arrows at the ends of the scroll bars to fine tune the selection to precisely
position the new start or end point.
To set a start or end point to a jump point in the design
• For designs that have multiple jump points, press the Jump Point arrows to move either the start or
end point to the next jump point in the design.
!
!
Drag the top scroll bar
to move the start point
to a new position in the
design.
Drag the bottom
scroll bar to move the
end point to a new
position in the design.