beautypg.com

Baby Lock ProStitcher Version 14.04.0051 (BLPS3) Instruction and Reference Guide User Manual

Page 14

background image

3.6 | Installation

Pro-Stitcher User Manual

3. Use the carriage as a guide and align the blue

Flexirack with the white gear along the length of

the table (see arrow at right), removing the pink

protective layer and pressing downward on the blue

Flexirack while moving down the entire length of the

table.

4. Double check the alignment of the carriage white gear with the blue Flexirack by rolling the carriage

along the entire length of the table.

5. Trim the Flexirack to length using a knife or wire

cutters. The blue Flexirack does not need to extend

the full width of the table and can be a couple of

inches shorter on either end.

6. At both ends of the blue Flexirack, use two of the

small metal clamps (see Parts List, item B) to hold the

ends firmly in place. The clamps have a hole through

the center and a lip on one end. The lip should be on

the side opposite the blue Flexirack. Place the clamps

where they will be attached and drill pilot holes

using the 3/32-inch drill bit and then use a Phillips

screwdriver to fasten the clamps on both sides of the

Flexirack to the table.

Lip