Licensing, Using a mouse or keyboard, Updating art & stitch – Baby Lock ProStitcher Version 14.04.0051 (BLPS3) Instruction and Reference Guide User Manual
Page 72

6.2 | Art & Stitch
Pro-Stitcher User Manual
unintentionally writing over a design. To avoid this, always save the design with a new working
name when it is directly loaded in
Art & Stitch.
Licensing
When using Art & Stitch for the first time, the quilter must enter some information to activate the license.
Refer to the instructions in the Art & Stitch software box for offline activation. All network connections
have intentionally been disabled on the Pro-Stitcher computer to prevent the computer from downloading
updates or viruses that would adversely affect the performance of Pro-Stitcher.
Using a mouse or keyboard
Many functions in Art & Stitch are much simpler when using a mouse and keyboard. When using the
pop-up keyboard, it may be necessary to press an area on the screen where the text is to be entered
before typing on the keyboard. While the pop-up keyboard is a quick keyboard solution, it may be more
convenient to use a conventional mouse and keyboard. The Pro-Stitcher computer works with most wired
and wireless USB keyboards and mice. Just plug the keyboard, mouse, or wireless dongle into an available
USB port, wait a minute for Windows to install appropriate drivers, and then use the keyboard or mouse. A
USB hub may be used to expand the number of available USB ports. Keyboards, mice, and USB hubs can be
purchased from most electronics retailers.
Updating Art & Stitch
Art & Stitch may need to be updated to the latest version for Pro-Stitcher to properly pass designs back and
forth. To download the latest version, use a computer that is connected to the Internet and go to the Baby
Lock website: www.babylock.com.
To update Art & Stitch
1. Go to the Products tab at the top of the page and select Upgrades/Updates. Follow the instructions to
download the latest version of Art & Stitch for Pro-Stitcher. After downloading this installation file, copy
it to a USB flash drive and plug it into the Pro-Stitcher computer.
2. Wait approximately 10 seconds for the Pro-Stitcher computer to set up the USB flash drive. Then select
Design, File, and press Update.
3. Browse to the appropriate folder on the USB flash drive and double-tap the Art & Stitch installation file.
The Pro-Stitcher software will close and the installation will begin.
Touch the gray bar
to open the pop-up
keyboard.
Press to close the
keyboard.
Use these buttons
to keep track of
changes you make
to the design.