Avery Dennison SNAP 500 - Manual (Page 79)

User’s Manual—SNAP™ 500 Gen 1 and Gen 2 79
8.2 Tape / Ink Advance
Problem Probable Cause Corrective Action
Tape or ink does not
advance when the
start button is
depressed.
1) No batches to be printed.
(Data light is not on.)
1) Download batch (If batch downloaded uses
the same design as a previously
downloaded batch, the machine will start
automatically).
2) An interlock condition exists.
(Supply or Error light is on.)
1) Press the voice button to determine the
error.
2) If using PCMate Platinum, check the virtual
control / display.
3) If using the Remote Control / Display
Module, view error message.
3) Tape is bound. 1) Remove and rethread the tape.
4) Ink is bound. 1) Remove and rethread the ink.
Tape tracks inward or
outward while printing
1) Stock Arbor Tension too low
2) Feed Assembly Alignment
Incorrect
3) Feed Assembly Damage
1) See Section 6.5
IF THE RECOMMENDED CORRECTIVE ACTIONS DO NOT
RESOLVE THE PROBLEM (S), CONTACT YOUR LOCAL
AVERY DENNISON REPRESENTATIVE.