Avery Dennison SNAP 500 - Manual (Page 77)

User’s Manual—SNAP™ 500 Gen 1 and Gen 2 77
8.0 Electrical Troubleshooting
8.1 Power Up / Sign On / Communications
Problem Probable Cause Corrective Action
LEDs do not light. 1) Insufficient supply voltage. 1) Look at the line voltage level shown on the
back of the printer (see Figure 5). Confirm
that the mains line voltage for your location
is within the range limits.
2) Machine is not plugged in. 1) Check that both ends of the power cord are
plugged in securely.
2) Confirm that the outlet the machine is
plugged into has power.
LEDs flash 1) PC board power failure 1) Cycle the power off and back on again.
Printer says “Boot Error
1” or “Hardware error
1. Printer requires
service” or “PCI
interface bad. Change
the MCB” during
power up
1) PCB failure 1) Replace MCB board
2) Motherboard failure 1) Replace motherboard
Printer says “Boot Error
2” or “Hardware error
2. Printer requires
service” or “BIOS
Corrupted. Replace
the motherboard or
reset the BIOS” during
power up
1) Corrupted BIOS 1) Connect a standard PC monitor and
keyboard to the printer and follow the
instructions found in the Engineering
Bulletin “06_015_500_BIOS_Revised.doc”
to reset the BIOS settings.
2) Motherboard failure 1) Replace motherboard
Printer says “Boot Error
3” or “Hardware error
3. Printer requires
service” or “Corrupted
safe operating system.
Replace the flash disk”
during power up.
(Message depends on
software version.)
1) Flash Disk Failure 1) Replace Flash Disk Module
2) Motherboard Failure 1) Replace motherboard