Avery Dennison SNAP 500 - Manual (Page 51)

User’s Manual—SNAP™ 500 Gen 1 and Gen 2 51
The printer has two Ethernet connectors. The one is on the motherboard is
not used. A network interface card must be installed on the printer. Contact
Avery Dennison Customer Service for a field installation.
Because the DHCP process may take some time, wait at least 1 minute after the
printer finishes its initialization (Ready light is on steady) before continuing.
4.4.3 Determining the DHCP Address
To find out the DHCP address that was assigned to the printer, you can print out
the Network ID Test Label. Load the printer with stock and ink and then follow
this procedure.
1. Press and hold the Voice button. Listen for “Press Start to print test patterns”
2. Press the Start button. “Press Start to print narrow setup test pattern”.
3. Press the Voice button. “Press Start to print wide setup test pattern.”
4. Press the Voice button. “Press Start to print Custom Test Pattern One.”
5. Press the Start button. “Ready to print Custom Test Pattern One. Returning to
print mode.”
6. The Data light will come on. Press Start to begin printing the Network ID Test
Pattern.
7. The Network ID Test Pattern label will have the temporary IP address printed on
it, see the picture below. If there is no IP address, there may be a problem with
your network connection. Check the connection and try again. If you can’t resolve
the problem, contact your Network Administrator.
Motherboard: Do not use.
Network Interface Card