Avery Dennison SNAP 500 - Manual (Page 20)

20 User’s Manual—SNAP™ 500 Gen 1 and Gen 2
2.5.4 Installing the Power Cord
A quick-disconnect power cord is shipped with each 115V printer. The cord for
115V printers will use the standard three-prong plug used in the U.S.A.
If a power cord is not supplied with your printer, and your printer is operating at a
voltage other than 115V, obtain a power cord for your application. The power
cord should have an IEC-320-C13 plug on one end and the appropriate plug for
your power receptacle at the other end.
1. Locate the AC power entry receptacle on the backside of the printer just
below the power switch (see Figure 5).
2. Plug the power cord into the AC power entry receptacle.
2.5.5 Installing the PC Interface Cable
If you will be using your SNAP 500 printer with a personal computer, one of the
following computer interface cables is required:
• Null-modem serial cable with Part number 05581139 connector
• USB / Serial adapter – Part number 05581140
• Ethernet adapter – Part number 05591105
1. Locate the communication cable connectors on the backside of the printer
(see Figure 6).
2. Plug in the serial cable connection to the serial port.
The default serial port setup in the printer is 115,200 baud, no parity, 8 data bits,
1 stop bit.
Figure 6: Rear View of the Printer
Serial Port for Communication to Printer
AC Connection for Power Cable
Power Switch
Auto Strapping
USB or Ethernet cards (if installed)