Avery Dennison SNAP 500 - Manual (Page 52)

52 User’s Manual—SNAP™ 500 Gen 1 and Gen 2
If no IP address prints on the Network ID Test Label, the printer may not
have completed the DHCP process. Wait a few minutes and try again.
If there is still a problem, make sure the network cable is connected proper
and check the other network connections.
If you still cannot obtain a DHCVP address, try resetting the printer to
DHCP mode as described below.
Finaly, set the static IP address manuallya nd test the network connect as
described below.
4.4.4 Converting the DHCP Address to a Static Address
Once you know the DHCP address, open a browser (Internet Explorer, Firefox,
etc.) on any computer connected to the network. In the address bar, enter the
DHCP address and press “Enter”. The following window will appear:
Click on the Network button. The
following window will appear.
The DHCP address is shown in the
IP Address box and the mode is
DHCP.
Enter the static IP address in the IP
Address box and click the “Submit
as Static address” button.
At this time, the IP address is set to
the static address and the web
server will no longer be available.