Avery Dennison SNAP 500 - Manual (Page 27)

User’s Manual—SNAP™ 500 Gen 1 and Gen 2 27
2. Remove the tape holding the end of the supply to the outer part of the roll.
To avoid damaging the rollers or print heads, use scissors to cut off any
portion of the supply that has adhesive on it.
3. Rotate the Tape Unwind Arbor Knob counterclockwise to retract the “fingers”.
4. To install the supply roll, begin with the leading end at the top of the roll
leading towards the stacker.
5. Slide the stock roll onto the Stock Arbor (see Figure 9).
6. Rotate the Stock Arbor knob counter-clockwise quickly to extend the fingers
that hold the supply roll in place.
7. With all print rollers in the open position, pull the stock from the top of the
supply roll.
Figure 9: Tape Supply Though Print Stations (Gen 2 shown)
8. Pull the roll of stock to the right of the Stock (web) Guide.
9. Continue threading the stock between the print rollers and print heads,
through the Feed Roller and up to the Auxiliary feed.
10. Rotate the Auxiliary Feed Knob counterclockwise and advance the stock
through the Knife and Nip Rollers and into the Stacker (until it extends about
½ inch or 10 mm - 15 mm from the rollers).
11. If the stock will not advance through the knife, refer to Section 5.4.2, Knife
Home Position Adjustment.
Print Rollers
Lower Print Station
Stock (Web) Guide
Fingers
Stock Arbor Knob
Auxiliary Feed
Supply
Roll
Knife
Nip
Rollers