Avery Dennison SNAP 500 - Manual (Page 42)

42 User’s Manual—SNAP™ 500 Gen 1 and Gen 2
4.2.3 Platform Angle
Adjust platform angle to alter the angle at which labels are stacked and stopped.
1. Loosen the Adjustment Thumb Screw and move the platform to an angle
approximately 20 degrees up on the outer end of the platform.
a. For satin labels, use the lower position.
b. For coated labels, and short feed labels, elevate the outer end.
The label stop helps position the labels in the stack. The label stop is magnetic.
Follow these steps to adjust the position of the label stop.
2. Place a cut label on the stacker platform and slide it into the back corner.
3. Move the label stop to within 1/8 inch (3 mm) of the end of the label.
Figure 15A: Stacker Platform Angle Adjustment
4.2.4 Height of Stack - Stacker Sensor
1. The stacker has an electronic sensor that automatically determines where
the top of the stack. There is no adjustment for the stacker sensor.
Figure 15B: LED Locations
Stacker Sensor
Adjustment
Thumb Screw
Platform Label Stop