Pilz PMCprotego D.72/000/0/0/2/208-480VAC - Manual (Page 85)

Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
4-51
4.4 Expansion cards
4 Function Description
 The transmission rate is set in the commissioning software using the
SBAUD # parameter. # is the transmission rate in MBit/s.
Change the optical output:
 Errors will occur in the telegram transmission if the optical output is
set incorrectly. The ERR LED will light.
 When communication is running normally, the RT and TT LEDs will
light.
 The optical range for a standard 1 mm² glass fibre cable is defined in
the commissioning software via the SLEN # parameter. # is the length
of the cable in metres.
4.4.6 Expansion card with DeviceNet interface
Expansion card with DeviceNet interface 4- ][Funktion_Erw_DeviceNet_protego_D
The DeviceNet expansion card is available as an accessory.
Fig. 4-16: Front view of DeviceNet expansion card
LEDs
The “Net status” LED shows the status of both the expansion card and
the network.
SBAUD SLEN
2 2 MBit/s 0 Very short connection
4 4 MBit/s 1…< 15 Length of the connection
with a 1 mm² plastic cable
8 8 MBit/s 15…< 30 Length of the connection
with a 1 mm² plastic cable
16 16 MBit/s 30 Length of the connection
with a 1 mm² plastic cable
LED Description
Off The device is offline.
- The device has not yet completed the Dup_MAC_ID test.
- The device may not be switched on.
Green The device is online and is running normally. The connec-
tions are established. The device is assigned to a master.