Pilz PMCprotego D.72/000/0/0/2/208-480VAC - Manual (Page 168)

6.8 Expansion cards
6 Wiring
Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
6-60
6.8.3 Expansion card PosI/O, PosI/O-AIO
Expansion card PosI/O, PosI/O-AIO 6- Verdrahtung
Please note:
If you wish to use the encoder emulation function you will need the ex-
pansion card PosI/O or PosI/O-AO. The expansion card is located in slot
2 or 3.
Funktion_INFO_PosI/O
][Verdr_Leiterquerschnitte_Verweis
Under “Connection cables”, please note the requirements for the:
 Cable cross sections
 Insulation material
6.8.3.1 Electronic gearing
Electronic gearing 6- ][Verdr_Emulation_Getriebe
Master-Slave mode
INFORMATION
A maximum of one expansion card PosI/O or PosI/O-AIO may
be used in a PMCprotego D.
Connector pin assignment
Connector X5 Pin Designation Description
1 GND Earth
2 n. c. --
3 n. c. --
4 A- Channel A inverted
5 A+ Channel A
6 B+ Channel B
7 B- Channel B inverted
8 n. c. --
9 n. c. --
n. c. = not connected
1
5
6
9