Pilz PMCprotego D.72/000/0/0/2/208-480VAC - Manual (Page 73)

Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
4-39
4.3 Control element
4 Function Description
4.3.8.3 Ethernet interface (in development)
Ethernet interface (in development) 4- ][Funktion_Ethernet_protego_D
The servo amplifier operates as an Ethernet subscriber. The connection
to Ethernet is made via the two 8-pin RJ45 sockets.
Communication is possible via the following network protocols:
 SafetyNET p RTFL (in development)
 Other protocols on request
Various operating and fault statuses are displayed via the LEDs on the
two RJ45 interfaces.
4.3.9 SD card
SD card 4- ][Funktion_MMC_protego_D
The top of the servo amplifier contains a card reader for an SD card.. The
memory card is used to download the firmware and parameter sets to
the servo amplifier.
Using the SD card you can quickly and easily commission an exchange
unit or identical axes on series machines.
RJ45 LED Name Signal Meaning
LED1 LINK_IN On Receipt is valid (IN port)
Off Invalid, power off or reset
LED2 CYCLIC On Network cyclical
Flashes Network not cyclical
Off Power off or reset
LED3 LINK_OUT On Receipt is valid (OUT port)
Off Invalid, power off or reset
LED4 REPEATER On Repeater on, network cyclical
Flashes Repeater on, network not cyclical
Off Repeater off, power off or reset
DANGER!
Only insert or remove the memory card when the servo amplifier
is switched off.
Carry out a reference run if you are using an absolute encoder or
have read in new parameters.
LED1
LED4
LED3
LED2