Pilz PMCprotego D.72/000/0/0/2/208-480VAC - Manual (Page 126)

6.6 Power element
6 Wiring
Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
6-18
][Verdr_Versorgung_24_V_protego_Sicherung
Use the following fuses, depending on the device type.
6.6.4 External brake resistor
External brake resistor 6- ][Verdr_Leiterquerschnitte_Verweis
Under “Connection cables”, please note the requirements for the:
 Cable cross sections
 Insulation material
][Verdr_Bremse_extern_protego_D_48_72
Connection
Output circuit Motor holding brake
Wires to the brake (BR+/BR-) should
be shielded
Connect the shielding on both ends
Fuse
Device type D.48 D.72 Type
Blow-out fuse or similar 8 A 8 A Fine wire fuse or
circuit breaker
Connector pin assignment
Connector X8 Designation Description
+RBe Connection of external brake resistor +
-RB Connection of external brake resistor -
1
2
PMCprotego X9A
BR+
BR-
M
BR +24 V
BRGND
X9B
L1
L3
L2
PE
1
2
X8
-RB U2 W2 V2 +RB -DC +DC PE