Pitney Bowes DI950 FastPac Inserter - Manual (Page 79)

SV61311 Rev. E 3-37
Basic Operation • 3
Insert Options
(continued)
Menu Item Associated Options and Actions
Additional Settings Double Detect allows the system sense when multiple inserts are
fed unintentionally.
NOTE: This menu option is not available when the job requires a
Custom Feeder.
•
Double Detect Feature allows you to toggle:
-
Off means this feature will not function for this item, or
- On means this feature is active.
• Locaton allows you to toggle:
-
Default, or
- Custom.
• Custom Locaton for Top Edge allows you to enter a specific
measurement (the distance from the edge feeding first into the
feeder) where the system should attempt to detect a double.
NOTE: Set this option when Location is set to "Custom". The
double detect region cannot be within 25 mm of the lead or trail
edges of the insert.
-
Use the UP/DOWN arrow keys to adjust the measurement
(in millimeters).
- Select "Accept" when you are done.
• Acton On Double allows you to select where the items should
be fed to if a double is detected.
Feeder Type allows you to change the Feeder setting when
material is problematic, or to indicate that the job requires a Custom
Feeder.
NOTE: This menu option is not available when the job requires an
Attached Printer.
•
Normal is used for most items.
• Manual Feed is used when items will be fed into the system
by hand. Refer to Manual Feeder in Chapter 2 for more
information.
• Custom Feeder is used when items will be fed into the system
by the Custom Feeder.
Feeder Linking allows multiple Feeders to feed the same material.
NOTE: This menu option is not available when the job requires a
Custom Feeder.
•
None means there is no linking of Feeder Trays.
• Two Feeders indicates that two Feeder Trays are linked and
feeding the same material.
Scan Items allows you to indicate whether or not an item should be
scanned.
Toggle:
•
Yes means this feature is active, or
• No means this feature will not function for the item.