Pitney Bowes DI950 FastPac Inserter - Manual (Page 134)

7-8 SV61311 Rev. E
7 • Add-On Modules
The Flats Sealer also contains an envelope edge marker. The envelope
edge marker will apply a mark at least 0.5" (12.5 mm) in length along the
edge of the envelope facing the operator.
You can use edge mark can be used to indicate tray breaks, ZIP breaks,
every 50th envelope, high value checks, etc.
NOTE: The envelope edge mark is applied only to envelopes passing through the
letter exit path.
Replacing the
Envelope Edge
Marker Roller
Follow the steps below to remove and replace the Envelope Edge Marker
Roller.
NOTE: Avoid touching the ink roller, as it is covered in ink.
1. Open the Flats Sealer cover.
2. Grasp the tab at the top of the old ink roller and lift to remove.
3. Grasp the tab at the top of the new ink roller and slide it onto the spin-
dle.
4. Release the tab once the ink roller is seated firmly in place.
5. Close the Flats Sealer cover.
Figure 7.9: Flats Sealer Cover Open
Envelope Edge Marker Roller
Flat Envelope Exit
Letter Envelope Exit