Pitney Bowes DI950 FastPac Inserter - Manual (Page 23)

SV61311 Rev. E 2-5
Meet the Inserting System • 2
There are two types of Feeder Trays:
• Sheet Trays
• Insert Trays
The required Tray type is based on the type of material selected for a given
job.
Feeder Trays
Sheet Trays Sheet Trays feed flat, unfolded material. Use only the recommended materi-
als. Refer to the specifications in Chapter 6.
NOTE: Sheet Trays have fill marks on their side walls. Be sure to keep your stack
of materials at or below these marks to avoid feed problems.
Figure 2.3.1: Sheet Trays