Pitney Bowes DI950 FastPac Inserter - Manual (Page 108)

5-16 SV61311 Rev. E
5 • Troubleshooting
Routine
Maintenance
NOTE: Wear on the moistener wick and brushes begins to compromise seal
quality at 250,000 machine cycles. It is recommended that you replace the wick
and brushes at this time. Please contact you system supplier to order supplies.
Refer to the Contact Informaton Lst at the front of this guide for more information.
Replace the moistener wick when it becomes dry. To do this:
1. Open the Insertion Area cover.
2. Place some paper towels on the Sealer deck to the left of the reservoir.
The towels will capture any water that may drip from the old wick car-
tridge.
This section outlines the maintenance tasks you can perform on the system.
Be sure to schedule routine service with your system supplier at the appro-
priate intervals.
• Remove any excess paper dust that has accumulated on or around the
system modules.
• Use a damp cloth to wipe unwanted soil marks from the covers.
• Report any system malfunctions and/or noticeable wear on system
parts to your supervisor.
Daily Tasks
Replacing the
Moistener Wick
Place paper towels on
Sealer deck.
Moistener Wick
Cartridge
Figure 5.1: Preparing for Wick Cartridge Removal