Pitney Bowes DI950 FastPac Inserter - Manual (Page 59)

SV61311 Rev. E 3-17
Basic Operation • 3
5. Shingle a 20mm to 50mm stack of envelopes. Place the envelopes into
the HCEF flap side down, flap last.
6. Finish loading a full stack of envelopes (up to 500 pieces), making sure
that the envelopes contact the back of the Side Guides. It is not neces-
sary to shingle the remaining envelopes.
NOTES:
• If an HCSF or Attached Printer is present, you may need to adjust guides to
ensure sheets feed correctly. Refer to Adjustng the HCSF Gudes or Adjust-
ng the Prnter Interface Gudes in Chapter 7 of this guide for more informa-
tion.
• If you are using scanning, you may need to adjust the scan head to ensure
the bar code or OMR mark is read. Refer to Adjustng the Scan Heads in
Chapter 8 of this guide for more information.
2. Place the envelope, bottom edge
first, into the Separator so the top
edge (flap crease) lines up with the
edge of the tab on the Wedge.
NOTE: The edge of the tab is indi-
cated by two arrows.
3. Lower the Separator completely,
then push down on the Separator
Gap Lever to lock it into place.
4. Pull the envelope out from the
HCEF.
Figure 3.8.3: Envelopes Lined Up with Tab on
Wedge.
Loading the
DI950 HCEF
(continued)