Pitney Bowes DI950 FastPac Inserter - Manual (Page 67)

SV61311 Rev. E 3-25
Basic Operation • 3
SwiftStart ™
Jobs
SwiftStart ™ mode allows you to run a simple job without entering any setup
information. In SwiftStart ™ mode, the system automatically senses the mate-
rial and sets the required parameters for running the job. A SwiftStart ™ job
can be run without saving the settings, or a Supervisor/Manager can name
and save the job for future recall and use.
Use SwiftStart
™ when your mail piece consists of only a small number of
sheets of one size that can be folded.
• A single sheet and a single insert will be taken from each loaded feeder,
giving a maximum mail piece content of: four sheets and three inserts
(DI900) or four sheets and four inserts (DI950). Fold will be determined
by sheet length and envelope depth.
NOTE: The maximum content options are available only when two HCSFs
are present.
• Maximum sheet length is 11-5/8" (297 mm)
• Only envelope depths of 4-1/4" to 6-3/8" (109 mm, 111 mm, 114 mm,
121 mm and 162 mm) can be used.
• Cannot be used to run fold only or inserts only.
• Cannot link feeders in this mode.
• Envelope sealer is always on (except on trial piece).
• Batch count is always off.
• This mode will not work with scanning.
• Address should be at the top of the sheet.
Starting the Job When your Trial Piece is verified, you are ready to start running the job. To
do this:
1. Make sure that you are in the Home screen.
2. Press START. The system will begin running the job.