Connecting to power, Powering up, Connecting to power -2 powering up -2 – Pitney Bowes DI950 FastPac Inserter User Manual
Page 44: 3 • basic operation, Powering up connecting to power
3-2
SV61311 Rev. E
3 • Basic Operation
Press the ON/OFF switch (located below the Control Panel) to start the
power up process.
NOTE: If a High Capacity Sheet Feeder (HCSF) is present, power on before you
power on the base.
The system will automatically conduct a number of checks to verify the op-
erational integrity of the system. If any problems are detected, the system
will display information directing you to a solution to the problem.
NOTE: When power cycling the system, be sure to power cycle any optional add-
on equipment as well.
Powering Up
Connecting to
Power
WARNING! Read the safety information in Chapter 1 before con-
necting the system to power.
To connect the system to power:
1. Connect the power cord to the socket on the back of the machine.
2. Plug the power cord into a suitable power outlet. Make sure the power
outlet is near the machine and is easily accessible.