Pitney Bowes DI950 FastPac Inserter - Manual (Page 64)

3-22 SV61311 Rev. E
3 • Basic Operation
Once the job setup is completed, you must run a trial piece to ensure sys-
tem function and to verify the accuracy of your final mail piece. Follow these
steps to run a trial piece:
1. Attach the Feeder Trays to the Feeder Tower. Refer to earlier sections in
this chapter for specific instructions.
NOTE: Highlight the Mail Piece Tree Icons on the Home screen for informa-
tion on the Tray type to use, orientation of the material in the Tray, and loca-
tion of the Tray on the Feeder Tower.
2. Load the mail piece components into the Feeder Trays.
3. Press TRIAL PIECE. The system collates all contents of the mail piece
according to the job parameters. The resulting mail piece is fed to the
Upper Divert Area waiting for your inspection. It does not go through the
Sealer. The Trial Piece Complete screen will display.
4. Examine the mail piece:
a. Remove the contents from the outer envelope.
b. Make sure the items are collated in the desired order and that the
destination address displays correctly, in the case of a windowed
enveloped.
c. Check for doubles.
Running a Trial
Piece