Pitney Bowes DI950 FastPac Inserter - Manual (Page 162)

8-18 SV61311 Rev. E
8 • Scanning
Menu Option Associated Options/Actions
Mark Location
Settings
NOTE: This option is
disabled when Content
in Line with Marks is
set to "No" and the
Scan Configuration
contains multi-mark
with fixed first and last
mark.
Allows you to setup various OMR mark-related
measurements:
•
Top of Page to Frst Mark is the distance from the top of
the page to the first mark.
• Total Length of Marks is the length from the top of the
first possible mark to the bottom of the last mark.
• Top of Page to Clear Zone is distance from the top of the
page to the beginning of the Clear Zone.
• Length of Clear Zone is the distance from the top of the
Clear Zone to the first mark.
Follow the steps below to enter the various mark-related
measurements:
a. Select an option, then use the UP/DOWN arrow keys to
enter the appropriate measurement (in millimeters).
b. Press "Accept" when you are done entering the
measurement.
c. Once all measurements have been entered, select
"Accept" to return to the Scan Settings screen.
NOTE: For more information about determining each of the
above measurements, refer to OMR Specfcatons in this
chapter.
Item Over Count
Quantity
Allows you to select the number of items that cannot be run
normally.
a. Use the UP/DOWN arrow keys to enter the item over
count quantity.
b. Select "Accept" when you are done.
NOTE: At this time, only a single scanned insert can be
added to each mail piece. The scanned insert must be a
Reply Envelope (BRE).
Item Over Count
Action
Allows you to select what will happen to items that exceed
the item over count quantity. Choices include:
•
Dvert – Select this option if the Scan Configuration does
not have the Divert Sheet (DVS) scan mark, and you
want the system to divert items once the item over count
quantity has been exceeded.
• Stop - Select this option if you want the system to stop
processing items once the item over count quantity has
been exceeded.
• Use Alternate Envelope – Select this option if the Scan
Configuration does not have the Envelope Select (ES)
scan mark, and you want the system to use an alternate
envelope for items that exceed the item overcount
quantity.
Refer to Scannng Features in this chapter for more
information on dynamic envelope selection and divert sheet
functionality.
Assigning
a Scan
Configuration
to an Existing
Job (continued)