EXFO FTB-800 Series for FTB-1 - Manual (Page 79)

Selecting and Starting a Test
NetBlazer 69
Ethernet Test Applications
Ethernet Test Applications
To select, configure, and start an Ethernet test:
1. From the test menu, tap Setup.
2. From the Test Applications tab, under Ethernet, tap a test icon.
3. From the Test Configurator tab configure the interface structure and
its parameters.
3a. Tap the Modify Structure button to set the basic structure of the
test such as the interface/rate, connector, etc. (refer to Modify
Structure Button on page 84).
3b. Tap the interface block to configure the interface parameters
(refer to page 77). Ensure that the link is up and the power level
(when supported) is present in the status bar before proceeding
to the next step (refer to Status Bar on page 26).
Modify Structure
Protocol Block
Test Block
Clock Block
Interface Block
Physical
Interface Port